Besides playing Videos and Graphics, our playout solutions also allow you to manage live input signals such as live studio signals or satellite feeds, and send them to the SDI or NDI®, SRT, UPD, RTMP, HLS, ST-2110 output.
We support switch to live in SD, HD and UHD, and the incoming signal and the output format, can be mixed for the channel (e.g., SDI IN / NDI OUT, SRT IN/NDI OUT).
Using an SDI based workflow, this can be done by…
…using the more traditional way by controlling a mixer/router.
…configuring the Playout Video device to do so.
Using the playout video device to switch to the Live Input signal means, that the video card synchronizes to the incoming video and not to the reference signal. To stabilize the signal in advance (i.e., before it is sent to the video card input) you must use a frame synchronizer which supports the playout format of your channel. Suited frame synchronizers can be found on the AJA Website or you can also use a Blackmagic Design ATEM switcher. If VANC data pass-through is required, an AJA FSx device (except for the mini), or any other frame store which allows passing through VANC data, has to be used. Please contact the manufacturer of all 3rd party video devices which are used with your setup to make sure, that they can handle the VANC data as needed.
With Switch to Live activated, the Live Input signal is grabbed from the SDI input and send to the Just Out engine. This process adds a delay or approximately 10 frames to the Live Input signal. This means that the signal, which has been received 10 frames ago, is visible at the output.
Works with all supported video devices, except the AJA KONA LHi and KONA LHe Plus.
Works in SD, HD and UHD, depending on the capabilities of the video device used for playout.
The incoming signal and the output format, can be mixed for the channel (e.g., SDI IN / NDI OUT, SDI IN/SRT OUT).
Live Input signal can be seen in the On Air view of the Just Control user interface.
VANC data which comes with the Live Input signal can be passed through to the output.
Using a Stream based live input workflow, this can be done by…
…using NDI®, SRT, UDP qualified Live Input sources alongside the classic SDI signals.
As for SDI Live Input it is crucial to use stable and frame rate accurate streaming input sources to obtain the best results.
Please refer to 2.8b NDI, SRT, UDP, RTMP, HLS Streaming Out (2025.4) for detailed information about the Input/Output setup for streaming sources.